Definitely user error then haha. I did have a quick go through one of the electromagnetics tutorials but I didn’t read them properly, my fault. Thanks for letting me know as I was fiddling around with ANSYS maxwell but specifying the pole directions in that was a pain. I even setup a flow region in maxwell to do the simulation and it never crossed my mind to do the same in simscale. I can probably get everything I need done now which is great. The results should also tell me if the iron backing plate is saturated right? In case I need to thicken it. N42 30x10x5 is what I am using, with 4mm thick iron plate.